Shenzhen Odyssey hit the ball pressure tester wholesale production of ball pressure test device

Ball Pressure Test parameters: ?

 1, according to GB4706.1-2005, GB2099.1-2008, GB/T5159.21-2006, IEC60695-10-2: 2003 and other standards made. 

 2, the ball pressure test is the requirement ball (R2.5mm) and total test force of 20N ± 0.2N ball pressure tester, the pressure level of the state and was placed in a heating chamber of the test surface, the test requirements temperature by 60min +2 min/0min, will test rapid (<10s) immersed in 20 ℃ ± 5 ℃ water cooling 6min 

 ± 2min, 3min removed from the water surface within the measurement of the indentation test diameter, depending on the indentation is more than 2mm in diameter to evaluate the test temperature specified in the 

 Heat deformation. 

Technical parameters:

1, the ball diameter: 5mm (R2.5mm)

2, the total test pressure: 20N ± 0.2N

3, samples bearing: Diameter 50mm, length 100mm Solid stainless steel cylinder

4, production of materials: all stainless steel

5, the reference standard: GB4706.1-2005, GB2099.1-2008, GB/T5159.21-2006, IEC60695-10-2: 2003

Note: it takes another ball pressure tester a high temperature box (oven) supporting the use